Looks nice. My old projector stand was OK for Super 8, but not big enough for 16mm, so I bought a cutting board and screwed that in place. When I got another 16mm projector, a stand came with it , which is much better, and a bit taller than the old one.
Posts: | 1.113 |
Points: | 3.214 |
Date registered | 05.19.2018 |
home: | United Kingdom |
ThankYou | 176 |
A 16mm projection stand should be at least 4ft high. This is to allow the projector beam to go over the heads of your seated audience.
Posts: | 817 |
Points: | 1.072 |
Date registered | 07.08.2017 |
home: | Bristol, United Kingdom |
ThankYou | 221 |
I've just got to wrap it well to take it home now,it completely folds flat so should be ok,handle back on later and ready to roll,Mark
Posts: | 817 |
Points: | 1.072 |
Date registered | 07.08.2017 |
home: | Bristol, United Kingdom |
ThankYou | 221 |
Your stand looks very nice! I use the dinner table, and I do light the back of my head if I don't slide down a little in the chair :-)
Posts: | 2.438 |
Points: | 7.328 |
Date registered | 10.12.2015 |
home: | Oslo, Norway |
ThankYou | 405 |
Thanks Elvind,I use this stand on the table and works well,it can extend quite high but I never use it that way,before this it was a book under the front of the projector to raise it up,much better now,Mark
I have one of these very portable I use it at blackpool very sturdy and strong
Posts: | 782 |
Points: | 899 |
Date registered | 09.28.2015 |
home: | lancashire |
ThankYou | 69 |